Sumbit your request
Leave your data!
Your request has been sent
We will contact you. Have a good day!
Navigation
Sand filter series MDS600
  • Single filter water flow: 50m3 / h
  • Pressure rating: 0.25Mpa~2.5Mpa
  • Working temperature range: 0 ~ 65 ° C
  • Effluent turbidity:less-than three
  • Inlet and outletConnection: flange
  • Turbidity can be controlled in less than 3 degree
  • Rated operating voltage: three-phase, 220v,380v,50HZ
  • Backwash water: for total filtered water 1 to 3%
  • Control mode: pressure control; PLC timing control;
  • Installation: vertical
Sand filter for cleaning water from mechanical impurities, the filter material in this case is quartz sand.
These filters are distinguished by their high efficiency, they perfectly cope with suspended particles, microorganisms and other impurities contained in water.
Principle of operation:
Water is supplied through the water supply port to the main chamber, passing through quartz sand and exiting through the drain port, leaving unwanted particles on the sand.
When the impurities in the sand accumulate and the pressure difference between the inlet and outlet of the filter reaches a predetermined value, the controller sends signals to the three-way, solenoid valves of the control system.
The inlet channel closes and at the same time opens the outlet channel, after which unwanted particles are washed out of the sand by a reverse flow and exit through a special drainage of dirt. If necessary, the cleaning cycle can be configured in time.




The advantages of our solutions

"Mide Technologies"

If you have any questions or need advice,
you can use the feedback form

Submit a request